Geekbox hard reset instructions.

[tygger]

Hello
I am looking for instruction on how to hard reset my geekbox.
I tried upgrading the firmware to android 6 but the device was not identified in the "Factory Tool".
After a couple of reset attempts with the "Update" Key pressed, the device turned on with only purple lights.

Can you please assist?
Do you have any techincal support for this device or instructions on how to hard reset it?

[gefattern]

Hi ,

what CPU , does it still boot to Android on TV ??? if not we must unbrick with shorten Pins ,

that you can flash your Box again , with working Rom , greetings / gefattern

[tygger]

Hi ,

what CPU , does it still boot to Android on TV ??? if not we must unbrick with shorten Pins ,

that you can flash your Box again , with working Rom , greetings / gefattern

Hi, Thanks for the reply!

- CPU is RK3368
- Its does not boot to android on the TV.

How do I Unbrick it?
What pins do I need to shorten?

[gefattern]

Hi, Thanks for the reply!

- CPU is RK3368
- Its does not boot to android on the TV.

How do I Unbrick it?
What pins do I need to shorten?

Hi ,

please search on big G for : Ugoos Reflashing in MASKROM , this Site will guide you ,

if you still have Questions ask , greetings / gefattern

[tygger]

Hi ,

please search on big G for : Ugoos Reflashing in MASKROM , this Site will guide you ,
if you still have Questions ask , greetings / gefattern

Hi, I found this site during my big G searches, however, the point where they say to shorten is not the same on my machine.
I'm afraid to do damage by shortening the wrong pins.

Can you help to point me to the right pins?

[gefattern]

Hi, I found this site during my big G searches, however, the point where they say to shorten is not the same on my machine.
I'm afraid to do damage by shortening the wrong pins.

Can you help to point me to the right pins?

Hi ,

you must make Pictures from both sides , ,thanks ,

greetings / gefattern

[tygger]

Hi ,

you must make Pictures from both sides , ,thanks ,

greetings / gefattern

Sorry, here is the other side,

[gefattern]

Sorry, here is the other side,

Hi ,

here the Problem begins , your Nand has not the typical solder Points , so it must unbricked by

shorten some other contacts on the back , i think near the Nand , but which i do not know ,

maybe a PCB Datasheet would help ??? , better someone that already did that , maybe on

Picture 1 the two silver Points above 15/..... Date , but not sure ,

greetings / gefattern

[RISCy Dude]

This site has schematics and other stuff. I have no experience with that site, I cannot vouch for its content.

A github with some Geekbox stuff. As before, I cannot vouch for the site's content.

Hope you find a solution.