NAND Chip Mask ROM Mode Short Location

[Pippo9]

Nobody can help me please?

I have the Zenoplige Z11 box. Inside is a TX3 PRO box (second photo).
I tried to update the firmware with sd card and firmware tx3 PRO, but when reboot I see red light and it's bricked.
I tried to connect it via USB with USB burning tool and I tried to short some pins without success.
Inside there is a NAND FORESEE NCEMASD9 08G.
Can someone help me with the procedure and pins to short to enter MASK Mode (so it is recognized by the PC)?

Thanks, I hope you can help me.

[soldiaz]

Try along the yellow marked stripe...gently try shorten pins until board gets recognized...

[sstefanov]

For my box this works:
(image could not be uploaded, so this is why I make next post)

[sstefanov]

Just short these pins.

[soldiaz]

@ thelinhlge

MAN !!!! it worked as you told!

My fault was that I tried to shorten after cable has been plugged in!!

This time I kept contacts on board with a fork and THEN connected USB!!!

Thanks a lot!

Btw.: device gets recognized again while plugging in so the fault depended on the tried firmware build...

[thelinhlge]

@ thelinhlge

MAN !!!! it worked as you told!

My fault was that I tried to shorten after cable has been plugged in!!

This time I kept contacts on board with a fork and THEN connected USB!!!

Thanks a lot!

Btw.: device gets recognized again while plugging in so the fault depended on the tried firmware build...

[m.morcielago]

@ thelinhlge

MAN !!!! it worked as you told!

My fault was that I tried to shorten after cable has been plugged in!!

This time I kept contacts on board with a fork and THEN connected USB!!!

Thanks a lot!

Btw.: device gets recognized again while plugging in so the fault depended on the tried firmware build...

Congratulations
did you flash your device successfully?

[soldiaz]

yes! back to life!

[nikanuka]

please help me to recognize Magicsee Iron (s905x) board - which pins to short





THGBMBG7D2KBAIL

TOSHIBA

MLC NAND Flash

update

https://forum.freaktab.com/forum/tv-player-support/amlogic-based-tv-players/s905x/646600-magicsee-iron-amlogic-905x-2-8-or-2-16gb-2-4ghz-wifi-fast-lan?p=765553#post765553

[letom]

Tanix TX9 Pro - Anybody knows which pins to short please?

[soldiaz]

letom gently try yellow pins. Shorten pins and while shortening connect mal-mal USB cable! You cant damage anything I tried almost any pins on my last S905x board :-P

[soldiaz]

TX9 pro has same firmware as TX92?? Hope you can revive..it is LP Memory...and mine refused to flash ..burning tool always exited at like 2%..

[nwizard]

Help me to find pins to be shorted, please...

[nwizard]

I have found the correct pins (I hope), but windows cannot recognize the USB device. World_Cup device driver is installed already as I burned a firmware into the box before...

[nwizard]

I point the pins - when I close them, my windows laptop do not recognize the box....