If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have the Zenoplige Z11 box. Inside is a TX3 PRO box (second photo).
I tried to update the firmware with sd card and firmware tx3 PRO, but when reboot I see red light and it's bricked.
I tried to connect it via USB with USB burning tool and I tried to short some pins without success.
Inside there is a NAND FORESEE NCEMASD9 08G.
Can someone help me with the procedure and pins to short to enter MASK Mode (so it is recognized by the PC)?
letom gently try yellow pins. Shorten pins and while shortening connect mal-mal USB cable! You cant damage anything I tried almost any pins on my last S905x board :-P
I have found the correct pins (I hope), but windows cannot recognize the USB device. World_Cup device driver is installed already as I burned a firmware into the box before...
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment