reset pins

[shadydawg]

hello again everyone can some one tell me where is the reset pins on this board.. i have tried pins from other post but they seem to do nothing.. I am trying to get my pc to see it so i can install the firmware on it the board is labeled

m8s_W_rev2.0 2018-07-09

its a meecool m8s pro w tv box

[gefattern]

hello again everyone can some one tell me where is the reset pins on this board.. i have tried pins from other post but they seem to do nothing.. I am trying to get my pc to see it so i can install the firmware on it the board is labeled

m8s_W_rev2.0 2018-07-09

its a meecool m8s pro w tv box

Hi ,

first , with this bad Picture , nobody really can help , the Chip u must use is the

NandChip , Picture / top of the Heatsink , then u must use the row on top , with

triangle (white) , not really sure which pins , on AML Box , but i think they are the

same as on any other Nand & Box , so you should try it with 7&8 ,

i hope you know how to do it , otherwise come back again and ask HERE for help ,

and i think it is better to move your Thread later to Mecool Section ,

good luck / gefattern

[shadydawg]

Hi ,

first , with this bad Picture , nobody really can help , the Chip u must use is the

NandChip , Picture / top of the Heatsink , then u must use the row on top , with

triangle (white) , not really sure which pins , on AML Box , but i think they are the

same as on any other Nand & Box , so you should try it with 7&8 ,

i hope you know how to do it , otherwise come back again and ask HERE for help ,

and i think it is better to move your Thread later to Mecool Section ,

good luck / gefattern

ahh thank you for your reply my phone has a crappy cam i will try get a better picture

[shadydawg]

hope this is a better view of it

[shadydawg]

was this the part you was describing?

[gefattern]

was this the part you was describing?

Hi ,

no , the Chip right beside this you marked ,

greetings / gefattern

[shadydawg]

Hi ,

no , the Chip right beside this you marked ,

greetings / gefattern

ah you meant this

[shadydawg]

If its possible can you mark the 7-8 pin that you mentioned.. To short those 2 i would need like a wire touching both of them while connecting the power?

Oh i think i know what you meant, I hve to count 7-8 from the triangle marked on the board?

[gefattern]

If its possible can you mark the 7-8 pin that you mentioned.. To short those 2 i would need like a wire touching both of them while connecting the power?

Oh i think i know what you meant, I hve to count 7-8 from the triangle marked on the board?

Hi ,

yes , that is what i mean , best to take a small piece of copper wire , or similar ,

it is really simple , but for sure you can look on YT too ,

good luck / gefattern

[shadydawg]

Hi ,

yes , that is what i mean , best to take a small piece of copper wire , or similar ,

it is really simple , but for sure you can look on YT too ,

good luck / gefattern

ok will give it a shot ty

[gefattern]

ok will give it a shot ty

Hi again ,

look what i found , maybe it helps :

https://forum.freaktab.com/forum/tv-player-support/amlogic-based-tv-players/s905/others-ac/firmware-roms-tools-bj/743742-mecool-m8s-pro-w-reset-pins

good luck / gefattern