LibreELEC and Armbian for Allwinner TV box

[balbes150]

Test version Libreelec (20200108) with support for installing LE in eMMC.

Tested on Tanix TX6. Before installing, be sure to make and save a full backup of eMMC (for this purpose, the system has a special item in the LE settings menu). The process of creating a full copy can take up to 20-30 minutes (depending on the SD card and filling eMMC data). After that, you can try running the installation in eMMC. Perhaps the first time you install the system will not be installed completely, you need to re-boot from the SD card and once again run the menu item install in eMMC. After completing the installation procedure, the system should automatically shut down. You need to turn off the power supplies and pull out the SD card. The first time you start the system, you will be asked to perform the initial system setup. Please note, this is the first test version of the installation in eMMC and possible side problems.

[balbes150]

New image Libreelec 20200106.

[balbes150]

universal image Armbian 19.11.4 20191228 , kernel 5.5 works H6

[balbes150]

New (20191224) generic images (they are in the shared directory RK+AML+AW) with a wired network fix. To run the universal image, it is necessary to add the correct u-boot to the SD card. Available u-boot file options can be found here.

https://yadi.sk/d/PIGjwjZ4m4HKqg

Instructions on how to write the desired u-boot (after recording the main image) is here.

https://forum.armbian.com/topic/12162-single-armbian-image-for-rk-aml-aw/

[balbes150]

Good news. Add support Eachlink H6

https://forum.armbian.com/topic/12162-single-armbian-image-for-rk-aml-aw/?do=findComment&comment=91507

[balbes150]

Good news.

Ready image 20191222 for Allwinner H6 (tested on Tanix TX6) which runs almost all the equipment except the built-in WiFi (works USB Wifi). While this is not a universal image for all models RK + AML+AW, but there is a prospect of refinement and obtaining a full universal version for these platforms (taking into account the personal settings of u-boot and DTB for each platform).

https://forum.armbian.com/topic/12162-single-armbian-image-for-rk-aml-aw/?do=findComment&comment=91478

[balbes150]

Build the first version of Armbian 20191221 19.11.4 kernel 5.5.0-rc2 for Allwinner H6 (Tanix TX6).

The system normally starts from the SD card. Works sound and USB devices (BT WiFi USB media etc), but there is a serious drawback until the wired network works. I have not yet figured out the reason why the wired network does not work, so I publish only two test images of Ubuntu and Debian, for a General assessment of the health of the system on Tanix TX6.

[balbes150]

Official versions of LibreELEC can be found in this thread on the official LE forum .
The main developer of these versions is Jernej.

https://forum.libreelec.tv/thread/17...and-h6-boards/



Unofficial versions of LE and Armbian for Allwinner H6

https://yadi.sk/d/GJbDt3-FjQ-dQA

MEGA

https://mega.nz/#F!j9QSDQSQ!6WpasOlbZYIInfw6yo4phQ