Unbrick Beelink Mini MXIII

[funben]

Get "MINI MXIII_107L1_0425.img" from

https://mega.nz/#F!M9FxDJZY!Qyf61LTqgARUUaW9k2bB7A

Get and install "USB Burning tool"

https://androidmtk.com/download-amlogic-usb-burning-tool

In "USB Burning tool" Import "MINI MXIII_107L1_0425.img"
then Start
Then use Paperclip to hold recovery button while plugin Male-Male USB to the box

YOU HAVE TO PLUG IT TO SIDE USB PORT (Next to MicroSD card Slot)

This is the trick, I have tempted many times using the bach USB Port with no success

Same method can apply to flash with other firmware, LibreElec, OpenElec
Now I will be tempting to install Armbian, and then install Jeedom server
Stay tune

...
I don't think anyone will read this since the box is from 2016, but if you do say hello, or thanks, or ask your question, I might still be around to discuss with you.

[funben]

Here I am again.
I successfully installed Armbian on an SDCard, and booted from it then I used the "Armbian configuration utility" to install onto eMMC.
Now the box is bricked, no signal to hdmi.

I tried to use the above method, and tried to brun the firmware on an SD card, but with no success.

What should I do from here ?

[neomode]

Hello,

You have to do this with the USB Burning Tool with a PC.
Also, it is needed to short the NAND Chip on the Board.
To do this the easy way would be to open USB Burning Tool Load the right Firmware press Start and connect the USB Cable to your Device.
Now take a Paper Clip and go over the Pins of the Nand Chip until the Burning Start?s.

Neomode

[funben]

Thanks for your answer.
I can do the burning with USB Burning tool with original Firmware. It ends successfully, but the system doesn’t boot.

I tried to redo the burning many times.

[neomode]

Maybe the Nand is defect or try it with Force Erase all.

[funben]

Who wants to have a good laugh ... My HDMI Cable was not plugged properly.

The box is fine, I now have to reinstall Armbian on SD card, and then try to copy it to eMMC