Unbrick Mecool K1 Plus S905D

[hudyj]

Hi. I have bricked Mecool K1 Plus S905D. There is no HDMI signal. I tried update several firmwares via SD card and USB (male to male) and nothing.
If I trying upload firmware by AMlogic USB Burning Tool software, shows error:

[0x10105002]Romcode/Initialize DDR/Read initialize status/USB Control setup error

What should I do? Do you have any solution of this issue? Should i use any short pin metod?

[neomode]

Hello,

Your problem can have several reasons.

1: Your USB Cable or Port does not deliver enough Power.

Try a different USB Cable or Power the TV Box while Flashing.

2: It is not the right Firmware for the Box.

Try a different Firmware for it.

Neomode

[hudyj]

Thank you for your response.
Does the cable need to be shielded?

[neomode]

Yes you should use a proper USB A to A Cable.
Also the quality of the cable must be good.

Neomode

[hudyj]

This time I used factory USB A-A cable (length 1,8m).
Which USB burning tool version should i use?

[0x10103003]Romcode/Initialize DDR/Download buffer/USB transfer error

[hudyj]

Anyone have any idea?