If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hi. I have bricked Mecool K1 Plus S905D. There is no HDMI signal. I tried update several firmwares via SD card and USB (male to male) and nothing.
If I trying upload firmware by AMlogic USB Burning Tool software, shows error:
[0x10105002]Romcode/Initialize DDR/Read initialize status/USB Control setup error
What should I do? Do you have any solution of this issue? Should i use any short pin metod?
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment