HardBrick h96 pro+ Wisdom

[mega-samu]

Hello, I recently flashed this rom "aml_7.1.2_s912_q9377-H96PROPLUS_mac-20171120_ubootfix_792Mhz.7z" on my h96 pro+ (rev wisdom). And the only thing I have obtained is a hard brick. Now I do not start the box, or detected by the PC.

I leave it as a warning, for those who are going to install this rom and to see if among all we can find a solution.

TEST:
USB_Burning_Tool = No detected (Before flash if I detected it.)
Burn_Card_Maker = The SD prepares well, but the box does not boot, even if the reset is pressed.

[Shonk]

to unbrick is make an sd card image
pull the power
plug in the sd card
hold down the recovery pin
plug in power
keep holding until it shows upgrading

this works from a bricked bootloader

[mega-samu]

to unbrick is make an sd card image
pull the power
plug in the sd card
hold down the recovery pin
plug in power
keep holding until it shows upgrading

this works from a bricked bootloader

And what is the recovery pin?
Edit: here are photos of this review: http://freaktab.com/forum/tv-player-...493#post706493

[mega-samu]

ok, fixed the tv box with this method: http://freaktab.com/forum/tv-player-...996#post706996

[TheRealDadBeard]

ok, fixed the tv box with this method: http://freaktab.com/forum/tv-player-...996#post706996

how did you manage to short it? i tried it aswell but had no luck!

[mega-samu]

how did you manage to short it? i tried it aswell but had no luck!

1- Prepare the amlburning with the ROM
2- I made a short pin with two needles
3- Without stopping, I connect it to the PC and it detects it.
4- Press to flash and you're done.

[arrfonseca]

mega-samu could you tell me the correct ROM to use? I have the same board

[NTAHS]

Hey guys I have a quite similar wisdom tv box and can't find the pins to unbrick. Any help?

https://photos.app.goo.gl/81GbbzKBSe5xCLKn6

[NTAHS]

Hey guys I have a quite similar wisdom tv box and can't find the pins to unbrick. Any help?