If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Open USB burn tool, connect side connection USB on gt1( don't plug other end to PC yet, import above image , where the cocktail stick is in photo, is where you need to bridge
Paper clip ,needle too thin, need a small screwdriver, to bridge them 2 connectors, press start on USB burn tool, plug other end to PC, now hold screwdriver on them 2 connectors,
It will make a low screech noise led will dim, and USB will connect and start burning ,
Good luck
You may only view thumbnails in this gallery.
This gallery has 1 photos.
I used a household cutlery knife but I wouldn't advise ,plastic handled electricians screwdriver would be ideal, do this at your own risk, all I can say is it worked for me
I have Bricked my box Mini M8S Pro which i had installed Beelink GT1 firmware GT1_709N0 and it worked good, but when I upgraded to GT1_710N1 the box has stop working. My Board is Different to can any one tell me which pins to connect (bridge)?
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment