If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Dears,
I have three dead V88 andriod boxes. Two of them were given green screen and while I was doing firmware upgrade via PC the operation failed and the boxes are not recognize by the PC anymore. Also the blue light is not working at all. The third one stopped working and it gives nothing 100% dead.
Would you please help and advise?
First please Test your Power Supply if they are still in good state.
Second, I would say you need to reflash the Box.
For that, you need to bring the Box to Mask Rom Mode.
This is done by shorting Pin 5&6 on the Nand Chip while connected to the PC.
After that, you should be able to reflash.
First please Test your Power Supply if they are still in good state.
Second, I would say you need to reflash the Box.
For that, you need to bring the Box to Mask Rom Mode.
This is done by shorting Pin 5&6 on the Nand Chip while connected to the PC.
After that, you should be able to reflash.
Regards
Neomode
Thank you for your kind reply.
I could short cut pin 5-6 in one box but I can't install the firmware always got failed message.
The other box gives light red light and short pin doesn't work.
What is the Failure Message?
Did you see Maskrom Mode in Flash Util?
Regards
Neomode
First, two boxes are working now! thank you.
The other one I got the failure message on loader start
fail loader start. and sometimes I got it after it while downloading firmware.
Then go to Maskrom Mode.
Delete the Loader in Util and reflash!
Neomode
Thank you. I'm using another program I don't have delete loader option.
Also, I have a question can I install firmware from another V88? I have MX4N and I faced many problems in it.
You probably use a wrong firmware.
Give us your wifi and motherboard name of each box.
With that we will can give you the correct link for the firmware
You probably use a wrong firmware.
Give us your wifi and motherboard name of each box.
With that we will can give you the correct link for the firmware
Thank you for your reply. I'm using the same firmware for all boxes. The seller provided me with it. but anyway I'll write it down:
Motherboard: XT-MX4N-V20 and I don't understand what do you mean by my wifi?
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment