If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have a UT1 non-T, and I tried to determine the CPU speed with the newest Firmware:
- App Antutu Benchmark
- App Antutu CPU master
- App Spec Device
- Integrated CPU speed prompting
In all cases, It's shown, that the CPU speed is 816MHz. If the UT1 is idle, or if I'm decoding a HD video with software decoder, at all times CPU speed is 816MHz only.
I have a UT1 non-T, and I tried to determine the CPU speed with the newest Firmware:
- App Antutu Benchmark
- App Antutu CPU master
- App Spec Device
- Integrated CPU speed prompting
In all cases, It's shown, that the CPU speed is 816MHz. If the UT1 is idle, or if I'm decoding a HD video with software decoder, at all times CPU speed is 816MHz only.
Is this a bug?
Best regards
akapuma
Sounds like a bug. Hopefully they are still working on the UT1 ROM because the last update was 5 months ago. The wasser 1.0.4. firmware is still unmatched regarding features and performance, but it was created with the old SDK. Can we hope for updates, Ava?
The wasser 1.0.4. firmware is still unmatched regarding features and performance
A good alternative to the wasser firmware is the firmware from allminipc, which was recommended by ugoos itself. The allminipc firmware has much more performance than the original ugoos firmware.
=> allminipc allows 720x576p. 720x576p is buggy in original ugoos firmware, so I must use 1280x720p. Much more pixels must be calculated, this is slower.
=> allminipc allows 1,6GHz. Original ugoos firmware allows only 0,8GHz
Result is, that it's not possible to play back SD video without micro jerkings. No problem with allminipc firmware,
I'm using the MXPlayer. With allminipc firmware, the MXPlayer menu opens after pressing the menu key on the remote control. This is OK.
But not with new ugoos firmware. If I'm pressing the menu key on the remote control during usage of the MXPlayer, all open Apps are shown (like a long pressing of the "Home" button on an android mobile.). This is not OK. I can't reach MXPlayer menu with the remote control.
Try the RED mouse mode button....that's why you have mouse mode.
Hello flhthemi,
I tested the red mouse button. The ugoos switches into the mouse mode. But the effect is the same. The "Menu" button is not the "Menu" button. It's like a long pressing of the "Home" button on an android mobile. => red mouse button does not solve the problem.
Regarding the resolution problem, I tested all video modes:
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment