I need to resurrect my UG802

[kingnaldo]

Hello

Sorry for my english but I from Cuba and live in spain.

I have UG802 Board HTC T002 V.0 Flash Finless ROM 1.7 Overclock 720p. The Aplication CPU SPY info the CPU not running at 1704Mhz. Uninstaller cpu control and instalL ANTUTU CPU MASTER after, install the ANTUTU BENCHMARK. Begin the test, but in the moment of graphic test, video off and never see again.
Not enter recovery mode and windows not detected.

Any help will be welcome
Gracias de antemano a todos.

[audiophonicz]

Try this:

http://androidpc.es/blog/2012/10/02/sacar-a-ug802-del-bucle-de-inicio-mala-actualizacion/

[kingnaldo]

Try this:

http://androidpc.es/blog/2012/10/02/...actualizacion/

Thanks but I've tried this method and Windows no detected any usb unit.
I have also tried other methods without results

short the nanad 8 and 9 pin, 6 and 7, 1 and 2 and nothing, not enter in rom mode.

Thak for your help

[kanglinyao]

I need to resurrect my UG802

Short 8,9 pins is the right way. The 8 and 9 pin are on the hdmi side. You count pins from in the middle of the board to out side. Try it. It should work .

[tatubias]

open the device

locate the following 2 point near the nand chip


shortcut with a cable or coin or srewdriver.

connect the device to the pc while you are doing the shotcut. then you will enter recovery mode.

Remember that you have to have installed the drivers for the device and the application to flash the device too.

Flash utilities / Drivers: http://www.mediafire.com/?qzwuw5ctqr8uba1

[ra111]

thanks - this worked for me mine is now recovered! shame opening it damages the case a little :S

[tatubias]

thanks - this worked for me mine is now recovered! shame opening it damages the case a little :S

good to know.

yes the case its not good at all

[elfruta]

Thanks!!

It workssss thanks

[tatubias]

It workssss thanks

in my case i did breake the micro ubs connector. was not well solder to the pcb

no im using a mk808 similar to the ug802.

[archideme]

Shortcutting 2 pins doesn't work for me!

My UG802 stuck on the first Finless 1.7 rom screen, no boot, no animation, nothing.
Shortcutting the indicated 2 pins doesn't work for me!
I tried to shortcut them while connecting microusb: the device goes up but I see always the same finless 1.7 screen and the device is not recognized on windows.
What can I try???
Thnaks in advance.

[Finless]

If it boots up then you are not properly shorting the pins!

I soldered a switch to mine to make sure it works when I need it.

Bob

[mciancio]

If it boots up then you are not properly shorting the pins!

Bob, you are GREAT! You were right: now, using a little metal paper clip to shortcut the pins, it goes in flash mode and I'm flashing your 1.8 rom.
THANKS!