URGENT! Bricked CX-919 ? PC does not detected it

[newone]

I have a CX-919, although I press the Function button and connect it to the pc (blue led is on), my pc does not detect it.
I have another unit and don't have any problems with it (so the usb cable, drivers are o.k.)
Is there any thing I could do?
Is There a way to reset the unit with a sd card?
I saw there is a way to reset the NAND chip will it help?
this is my unit

Does the NAND chip is marked with: "model: Flash: 8Gb DDR: 2Gb" ?
What is the procedure for it?

[Jimandroidpc]

hold the flash button in before you plug it in. then unplug it, and try to plug it in again with the flash button held. I had the same issue and some combination worked.

[newone]

URGENT! Bricked CX-919 ? PC does not detected it

hold the flash button in before you plug it in. then unplug it, and try to plug it in again with the flash button held. I had the same issue and some combination worked.

Tried it but it didn't work

Any one tried to unbrick cx-919?

[Metativ]

Mask-Mode

Had the same problem.

Search the forum for cx-919 and mask mode or look at this link here:

http://www.freaktab.com/showthread.php?9712-How-to-boot-CX919-in-quot-Mask-ROM-mode-quot

After some trries i finally get my cx-919 back to life and flashed this ROM, which works wonderful.
But i must say, that i have an RK3188-T Model, V.1.1

http://www.freaktab.com/showthread.php?9389-NEW-Finless-ROM-2-0-KitKat-4-4-2-for-AP6210-wifi-BETA