mk888 briked ?

[bellad]

yes , but the pc no detect mk888 even with usb debbogge checked

[no_spam_for_me]

yes , but the pc no detect mk888 even with usb debbogge checked

Try these settings in android
Settings -> [DEVICE] USB -> Enable Connect to PC
Settings -> [PERSONAL] Security -> Enable Unknown Sources
Settings -> [SYSTEM] Developer options -> Enable USB debugging

[no_spam_for_me]

Hello I have a MK809II clon TV stick bricked. I've tried all the tricks of this thread to unbrick it but I couldn't make it work again. I connect it to the PC, is recognized as mask mode but 8 seconds later it powers itself off, and it's no longer detected even thoug it remains connected to the pc. I've never found a similar issue around.

"and it's no longer detected even thoug it remains connected" => what does it mean? can you explain?

Try to do
7) erase nand (idb)
and/or
8) flash the firmware of your choice
as fast as possible... Maybe it avoids the reboot

[bellad]

Try these settings in android
Settings -> [DEVICE] USB -> Enable Connect to PC
Settings -> [PERSONAL] Security -> Enable Unknown Sources
Settings -> [SYSTEM] Developer options -> Enable USB debugging

yes i try , nothing..

ok , is good , i have changed of pc

thank you
I still have to change the libmedia.so

[fcolmedo]

"and it's no longer detected even thoug it remains connected" => what does it mean? can you explain?

Try to do
7) erase nand (idb)
and/or
8) flash the firmware of your choice
as fast as possible... Maybe it avoids the reboot

Sorry, my english is not good.
At first the pc detects the stick in mask mode. But 8 seconds later the sticks powers itself off, the red led is off as it's no longer detected by the pc. It's like it was unplugged from the pc but in fact it's still plugged into one pc's usb port.
The same thing happens when I plug it in the power supply, just 8 seconds later it powers itself off.
In the 8 seconds available I could erase nand but in that short time I obviously can't flash it .
Thanks for your concern.

[no_spam_for_me]

OK, because it is off the PC can't recognize it any longer...

But if you're able to start the process (erase OR flash) my hope was, that it doesn't turn off during that process...

[eve_Snuffy]

I would suggest you check your power supply. I have the suspicion that it is corrupt...

This post was created with Tapatalk. Plesse excuse any spelling errors. I'll do my very best.