stuck 802-2 at logo - help please

[genseric]

well, i think i kinda bricked the new 802-v2 clone. first i installed the 1080p of the old 1.7 version and did not liked the resolution so i wanted to flash the 720p version. it did not boot back so i applied the finless' post (http://www.freaktab.com/showthread.p...inless-1-7-rom) and it was recognized by the batchtool. but there was no update.img for the v2 so i applied the v1's update img and it was installed. but i had to install the stock rom so i flashed the stock rom for v2 , just forgot the erase the nand. now the device is stuck at the v1's penguins boot logo. the machine is not all brick but it's not going anywhere from here.

guys, help me out here please.

[genseric]

and the wiring method does not work this time..

[genseric]

well, i figured it out myself. it seems connecting two solder points must be done with a good cable. cant figure out why the first one did good in the first place. i resetted again with the v1 4.01 something update.img and tried the Clone UG802-2 Stock ROM but it failed again. so i did all over again and this time flashed the 720p of the 1.7 old finless rom and it's running all good.

love this forum.