After failed cwm install my 802 mkiiis ap6210 was stuck in cwm loop. I shorted pins 8&9 and now blue light is on but no HDMI output. Am I in mask mode or is this because nand erased? I have the San disk nand chip I shorted 7-8/8-9/9/10 top left side of chip. Seen post with 5-6 pins on top right side. Did I brick device by shortening left side pins?
-
Last edited by moose m79; 12 July 2015, 23:47. -
You have to connect device to PC while shorting the pins then the flash tool will become blue and tell you mask rom mode.Originally posted by moose m79 View Post
Then you can flash your stock ROM back. -
Thank you I just discovered that all my USB cables are charging only. On the way to buy new cable. Hope this works. Do I uncheck loader for W2comp stock firmware after clear IDB?Comment
-
ok shorted pins 5-6 both tools recognized rkbatchtool 1.8 recognized blue square i selected firmware and hit restore goes to reset device then yellow lights goes off. log includedComment
There are currently 1943 users online. 1 members and 1942 guests.
Most users ever online was 63,956 at 18:56 on 20 March 2025.
Comment