Hello sir,
i have a MXIII 4k box which cannot display anything on TV, i tried different methods (USB recovery (including short pin 8+9 from flash, SD card) but i cannot get running ,
I plug power connect it is red if press power will switch to blue
I try several way to recover my box but unfortunately both of them was good.
With Usb Burning Tool i get many error and the flash methods not go up the 2%. Many error like this "Romcode/Initialize DDR/Read initialize status/USB Control setup error"USB method always stop on 2% with message DDR......
can i get a advice for which method i can use and a correct firmware for this?
the sticker on the back it is MXIIIS8022G8GAP6330 2G
i guess S802 processor , 2G ram 8G flash wireless AP6330
the box it is identified K200C
thank you
i have a MXIII 4k box which cannot display anything on TV, i tried different methods (USB recovery (including short pin 8+9 from flash, SD card) but i cannot get running ,
I plug power connect it is red if press power will switch to blue
I try several way to recover my box but unfortunately both of them was good.
With Usb Burning Tool i get many error and the flash methods not go up the 2%. Many error like this "Romcode/Initialize DDR/Read initialize status/USB Control setup error"USB method always stop on 2% with message DDR......
can i get a advice for which method i can use and a correct firmware for this?
the sticker on the back it is MXIIIS8022G8GAP6330 2G
i guess S802 processor , 2G ram 8G flash wireless AP6330
the box it is identified K200C
thank you