If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have a MXQ Pro+ 4K from China which was running on Android 5.1.1 having 1GB of Ram. After restoring the stock build.prop the box is not going beyond MBOX screen (with distorted display). I tried to enter recovery using the recovery button inside AV socket but it not going into recovery and just boots to that MBOX screen only.
I have tried using AMLOGIC USB Flash Tool but that also fails. Tool recognises the box on HUB3-2 but gives error "[0x00101004]Erase bootloader/Lowper/Identify/Error result"
Now what to do and how to enter recovery to either wipe or reflash stock img???
I have a MXQ Pro+ 4K from China which was running on Android 5.1.1 having 1GB of Ram. After restoring the stock build.prop the box is not going beyond MBOX screen (with distorted display). I tried to enter recovery using the recovery button inside AV socket but it not going into recovery and just boots to that MBOX screen only.
I have tried using AMLOGIC USB Flash Tool but that also fails. Tool recognises the box on HUB3-2 but gives error "[0x00101004]Erase bootloader/Lowper/Identify/Error result"
Now what to do and how to enter recovery to either wipe or reflash stock img???
skype me nickd010 i know how to make it work i created my own firmware looks and act just like the nvida shield everything works great
Finally managed to flash latest MXQ Pro+ using USB Tool and booting trough shorting nand pins. Reset button didn't work at all. It seems it has not been connected properly.
I have shorted the pins marked with red color arrow. You need to be little patient it may not happen in one shot. Just touch in between 2 pins with fine pointed screwdriver or anything of metal (in my case I used multimeter pin). Make sure HDMI is connected to TV (to make sure box isn't booting normally) and USB cable (A2A) to computer with all drivers loaded and USB Boot Tool (I used 2.0.6) running.
Touch pins and insert USB to USB Port 4. USB Tool should detect the connection but nothing will be displayed on the TV.
Your board may not be same, so make sure you know what you are doing.
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment