H96 Pro + does not turn on

[UkrStranger]

Hi everyone.

My H96 Pro+ does not turn on. I already tried few different images from this website, but the box don't give me any reaction.

It was in working condition from the box, but when I try to install different firmware, it became bricked. Even installation process didn't start. I turn the power off, then put sd card with firmware in TV box, push reset, and turn the power on. After this only "no signal" message on my tv, when I power it on, or when I try to install another firmware, and blue LED always burning,

It have blue board CZ-S32-V6, 20180103, 3+32+9377 model

I will be grateful for any help.

[ch3mn3y]

Try with USB Burning Tool and male2male USB cable? At least You will know where is the problem as toll will show log.
Maybe You've "bricked" the memory and will have to short its pins.

[UkrStranger]

Thanks for quick response!

I'll buy cable, and try it tomorrow.

Can you write me more details about pins short? Or link to correct topic?

Also tell me please, what firmware from this forum you can advise for my box?

http://freaktab.com/forum/tv-player-...7-wifi-chipset - this one should works ok?

[ch3mn3y]

This one, ATV or any official one for V5 and V6: https://mega.nz/#F!8qhRRaYJ!2ZA3VLjv...TF27g!prxFnCRA

I would look in this thread for correct pins: http://freaktab.com/forum/tv-player-...n-unbrick-help
Maybe even ask there if someone knows correct ones?
This post may be helpful: http://freaktab.com/forum/tv-player-...734#post646734
It shows correct pins, but for older PCB variant, but if 29 and 30 are still the right ones You may find them by counting the pins on Your board...

But first try with Tool, without shorting pins as it may not be needed. It may give You errors few time, just push reset and it will start over the flashing process. For me, flashing rom You gave link, took 3 or 4 tries. Some people have to keep pushing the reset for whole process :P