Ugoos UM2

[fonix232]

Just received this stick, and while being awesome (better design than previous sticks, smaller PCB, two USB host ports), it has a few kirks. For one, there is no OTG on the OTG port at all, I cannot even get to be recognized. Does anyone have any idea?

Images:

https://drive.google.com/folderview?id=0B1QjyBea5l6kTDVhY1g5VjlsekU&usp=sharing

[neomode]

No worries Bro this Device has an OTG Port, but the Chinese Way
What you need is a Cable with a USB Connector Type A to Type A.
The Wiring is one to one.
I know this is no Standard Cable, may you can make it by Yourself.

Neomode

[fonix232]

No worries Bro this Device has an OTG Port, but the Chinese Way
What you need is a Cable with a USB Connector Type A to Type A.
The Wiring is one to one.
I know this is no Standard Cable, may you can make it by Yourself.

Neomode

Yes I can but I still don't understand why not to use the microUSB port. Is it even possible? I took a few shots of that port, but I cannot see any actual connection to the data pins, only the power and ground were pulled up (though I might be wrong, especially if this is a layered PCB and the microUSB is routed in an inner layer).

[neomode]

AW: Ugoos UM2

Maybe I don't have this Device here.
But look you only need this Cable for flashing. I don't would do a re routing of the Data Pins.
I don't know why Ugoos have make it like this :banghead:

Neomode

Gesendet von meinem GT-I9305 mit Tapatalk 2