T95Z Plus No wifi

[rutters]

Can't seem to get this box to connect to my wifi. At the moment it is not detecting my wifi at all. At other times it shows in the 'available networks' but will not connect, either saying 'saved' or 'disabled'.

Is there a solution please?

[X92-2GB]

Does it show other AP connections available? If so, when you do see your router, is it on top of all the others?

I have had that issue once or twice... vaguely remember the issues were with channels being too congested. Had to scan for the best channel to use with 2.4Ghz N. Found I also had to adjust the router to use upper or lower edge of the channel, where less overlap is. You want at least 30db of usable signal floor from the top of your channel.

[rutters]

Thanks for replying.

It detects my neighbour's wifi and when mine appears it is at the top of the list.

[X92-2GB]

Thanks for replying.

It detects my neighbour's wifi and when mine appears it is at the top of the list.

Do you get a full signal? No partial signal.

[rutters]

Not sure what you mean. Do you mean signal strength? I get 5 bars for neighbour wifi and his is always in the 'available networks' list

[X92-2GB]

How close is the router, and is there a direct line of sight, or is there obstacles, walls, or 2.5ghz, or 5GHz cordless phones near by. Your signal should for the most part be full bars when connecting the box.

also if you used a firmware not from your manufacturer, it could have driver issues.