New Stock Firmware and GT King Pro 906P0

[clarkss12]

There has been a fix but as always, please advise:
https://beelink-my.sharepoint.com/:f...PHByA?e=j431uu

Repair:
1. Optimize the system
2. Join Miracast (Android phone can cast screen to the box)
3. The version number is 906P0
4. Add sd card brush function


OTA will be pushed for previous version

Thanks, again, Trebor. Downloading now.

[clarkss12]

There has been a fix but as always, please advise:
https://beelink-my.sharepoint.com/:f...PHByA?e=j431uu

Repair:
1. Optimize the system
2. Join Miracast (Android phone can cast screen to the box)
3. The version number is 906P0
4. Add sd card brush function


OTA will be pushed for previous version

This must be the same version, voice still
does not work.

[trebor]

There was no mention of voice fix for version, I can get voice to work
Hold and Speak.

[clarkss12]

Doesn't work for me Trebor.

[trebor]

If not done already try
Set remote to USA in the language and input settings

[DasXardas]

I have this version, updated via OTA, but It makes my WiFi and BT unusable. I can't see any AC networks and also N networks with 40MHz channel width and many others I'm unable to connect. If I successfully connect to some AP (some G, N sites with 20MHz channel width and on specific channels) so I've got very poor speeds Do you have anybody the same issues? I hope that they will fix that soon. Also I hope that they build x64 rom.

[Pugnetta]

I have a beelink Gt King SN: 95X2 which was bricked thanks to this?? http://www.bee-link.com/forum.ph ... ge=1&authorid=1   I managed to bring it back to life. Then I start from the original firmware of my GTKing_901K0_20190509 box and then via OTA or manual I get to 905PO but at the next 906PO it hangs on the Beelink Logo. The same is true even if I use USB_Burning_Tool with the 906PO firmware stops on the Beelink Logo I can't understand why would anyone help me in this regard? Thanks !!