New firmware android 9.0 for Amlogic S905x

[NylonStereo]

https://forum.freaktab.com/forum/mai...short-location

Thanks, I knew about that thread. I located 4 pairs of pins that can be shorted but none of them seems to work to make the X96 recognizable.

[sagert]

https://forum.freaktab.com/forum/main-category/main-forum/637675-nand-chip-mask-rom-moode-short-location

[NylonStereo]

It is necessary to write what error in USB burning tool.

It's not recognized by the PC or USB Burning Tool. It seems completely dead except for the red led. Last time it was alive was when I loaded an atvexperience firmware "successfully". Everything seemed fined up to that point,.

[timosat]

Is it possible to install Magisk on atvxperience pie rom?. I know its rooted with superSU but I wànt Magisk installed.

[sagert]

It is necessary to write what error in USB burning tool.

[NylonStereo]

Solid red light when turning on, shorting any pins doesn't do anything. I think it's completely bricked, isn't it? (I had "successfully" loaded a firmware).

[sagert]

I finally made it work. I noticed in the Windows Device Manager that the device was recognized. I uninstalled the drivers and Burning Tool found it. Oh, and it's pins 1-2 on my device.

Congratulations.

[NylonStereo]

I wish I could. I tried with the burning tool and with the magic card but I can't get it to connect or recognize the card.

I finally made it work. I noticed in the Windows Device Manager that the device was recognized. I uninstalled the drivers and Burning Tool found it. Oh, and it's pins 1-2 on my device.

[NylonStereo]

Install android 7.

I wish I could. I tried with the burning tool and with the magic card but I can't get it to connect or recognize the card.

[NylonStereo]

Should the light turn off while you're shorting the pins? It does turn off on mine.

[sagert]

OK, thanks. I read all I could find. As far as I found out, everyone with the same model (QX5 V2.0 with Samsung NAND) was unsuccessful.

I'm going backwards, it was booting and working, now it doesn't come out of the boot animation.

Install android 7.

[NylonStereo]

You had to take your time if you had no experience.Now read more about the topic of mask rom.Find out how others came out of this situation.

OK, thanks. I read all I could find. As far as I found out, everyone with the same model (QX5 V2.0 with Samsung NAND) was unsuccessful.

I'm going backwards, it was booting and working, now it doesn't come out of the boot animation.

[sagert]

There are several firmwares in this topic .There are firmware with recovery for example daivietpda but there recovery is difficcult to installl.You need to read more about this topic.There are firmware from atvexperience here.

[sagert]

I think I tried every pin combination on the NAND and all I get is reboots. (X96 2/16 v2.0)

You had to take your time if you had no experience.Now read more about the topic of mask rom.Find out how others came out of this situation.

[NylonStereo]

There is a topic here on the mask rom website.

I think I tried every pin combination on the NAND and all I get is reboots. (X96 2/16 v2.0)