how to open h96 pro?

[crebelo]

Guys how do you h96 pro? trying to open it to check board for the version.
I seem to have a strage configuration of 3gb/16gb wich i coulnd find any firmware...but first...no screws anywhere but it seems to be held somehow in the corners?!

thanks.

[kwabh]

Did you solve your temporary problem. Look at the back of the box where all ports are situated. look where the HDMI port is . Underneath on the frame of the box you can insert some hand pressure ,it will open slightly. Then on further right hand side you can introduce a thin screwdriver , there will appear a gap in the body work, You can manage from here. Do not apply too much hand or tool pressure on the plastic bodywork. Replace the bottom lid as it was originally 'spotted' before opening the box. Careful about small plastic levers to click the bottom part.

Secondly if you find a 4th hidden USB port(not seen outside) on the motherboard ., please let me know. GOOD LUCK.


Best Wishes, kwabh

[freddy]

Hi kwabh

This is old thread
However
There is 2 slots/openings on mine on backside for small terminal driver,plus under HDMI
Likes you described

I have Pro Plus 3/32 similar
There are 2 USB ports hidden/not used on my board.

I just took it apart to look.

THank you for info/Tip

Iam going to Test them

[kwabh]

Thanks very much. The 2 USB hidden/unused after you test them,
please let me know for what purpose we can use these additional ports.
I do not know whether the motherboard can handle one internet antenna.
I do not have much electronic knowledge.
Thanks .RGDS,
kwabh

[freddy]

I did test them
And they worked
I notched the side of the case out with extra fine 32Teethper inch broken hacksaw blade
Then chainsaw file on edge.

Use them for Whatever you want

I not sure why they covered them up...

This Box is my Nemisis.......

Have never been able to Get HDMI output to work

Its a long story

[kwabh]

Thanks.
I have already cut-opened one box, I am using same for my mouse pad.
HDMI:- the port has something to do or the end connector-plug. Very fragile.

So how did you get A?V out to TV ?

Best Wishes,
Rgds,
kwabh

[freddy]

THe AV port on back of Box

[kwabh]

Thanks for pointing out the alternative method.

[freddy]

No Probs

CVBS Resolution suks...

Most/ all TV Boxes have AV Port.

Usually we are sticking Toothpick in there to Enter REcovery Mode.

Lol

However is only way to verify Flash Successful