A95X F3 S905x3 issues

[cikkucippic]

I have to return a brand new box, back for complete refund.

Switching the box on for the first time, and the box is stuck on logo “ A95X “ The recovery mode shows that the software is Droid/ampere/ampere etc etc
Seller sent me a recovery rom. It’s the 309, intended for the Air model . Mine is RGB . The software is A95X F3 -S905X3-D3X4.zip

It worked ok for a few hours without any apps installed, but, “ mobdro” and “ cloudtv pro “ were included with the firmware
uninstalling “ mobdro” , and “ cloud tv” fixed problems when entering settings.

But, when the box was switched off and on again, it failed again.
Leaving the rom installed, I switched on the box, with a burned SD card , burnt with the same firmware, and pressing the usual AV recovery switch . As soon as I could see the robot at start up, I released the switch, and the box was working ok, only to find that it was now, overheating !
Next switch on, failed again.

There are scores of variants of this software , but , apparently, none is ideal for the RGB version.
I am suspecting that my box is actually an F2 not F3, because the only firmware, available, specifically for the RGB model is for the F2 box.

I have seen seen scores of complaints about this box, and it’s variants, AIR, Slim etc etc.

this is an eye opener for would be buyers

good luck

[gefattern]

I have to return a brand new box, back for complete refund.

Switching the box on for the first time, and the box is stuck on logo “ A95X “ The recovery mode shows that the software is Droid/ampere/ampere etc etc
Seller sent me a recovery rom. It’s the 309, intended for the Air model . Mine is RGB . The software is A95X F3 -S905X3-D3X4.zip

It worked ok for a few hours without any apps installed, but, “ mobdro” and “ cloudtv pro “ were included with the firmware
uninstalling “ mobdro” , and “ cloud tv” fixed problems when entering settings.

But, when the box was switched off and on again, it failed again.
Leaving the rom installed, I switched on the box, with a burned SD card , burnt with the same firmware, and pressing the usual AV recovery switch . As soon as I could see the robot at start up, I released the switch, and the box was working ok, only to find that it was now, overheating !
Next switch on, failed again.

There are scores of variants of this software , but , apparently, none is ideal for the RGB version.
I am suspecting that my box is actually an F2 not F3, because the only firmware, available, specifically for the RGB model is for the F2 box.

I have seen seen scores of complaints about this box, and it’s variants, AIR, Slim etc etc.

this is an eye opener for would be buyers

good luck

Hi ,

for sure a faulty Box , dont buy this cheap No Name Boxes , buy a better supported Box , there are several

CustomRoms for S905x3 Boxes , but Wifichip must fit , let them refund it ,

greetings / gefattern

[Gante]

I do not understand. If it's an RGB model, why give into the box the Air version there? She will go here as well, but the box then heats up excessively and eventually throws an error.
Put the firmware for the RGB version there and you'll see what it does.

Gefattern, no offense - just a note, but as I read here, every box is bad for you.

[cikkucippic]

I am sending it back, because it is very unstable. It may have NAND problems, together with a wrong software