USB burning Tool s905x Unplugged Accidentally When Flashing Started

[AnasTechInfo]

Dear Community:
I had a S905X box. I was flashing Atvxperiance v4 image in it using USB burning tool.
At the time flashing started, I got my box disconnected accidentally.
Now I'm trying to flash it again but unfortunately Amlogic Burning Too is showing below mentioned errors.
uboot/get result/diskinitial error
romcode/switch status/identify/error result
Can anyone help me please!

[gefattern]

Dear Community:
I had a S905X box. I was flashing Atvxperiance v4 image in it using USB burning tool.
At the time flashing started, I got my box disconnected accidentally.
Now I'm trying to flash it again but unfortunately Amlogic Burning Too is showing below mentioned errors.
uboot/get result/diskinitial error
romcode/switch status/identify/error result
Can anyone help me please!

Hi ,

that is not good , maybe you can try it over SDFlash , or shorten Pins to get your Box in MaskromMode ,

to flash it , how many % was shown while flashing when disconnected ,

try it over MaskromMode , for more Info look here :

https://forum.freaktab.com/node/637675

further good luck

greetings / gefattern

[AnasTechInfo]

Hi ,

that is not good , maybe you can try it over SDFlash , or shorten Pins to get your Box in MaskromMode ,

to flash it , how many % was shown while flashing when disconnected ,

try it over MaskromMode , for more Info look here :

https://forum.freaktab.com/node/637675

further good luck

greetings / gefattern

Percentage was around 1 to 2 percent (I think) as it was just started.
I'll try maskrommode and will update accordingly

[AnasTechInfo]

Images of my board are attached as I didn't find mine in that thread.

[gefattern]

Images of my board are attached as I didn't find mine in that thread.

Hi ,

look your second posted Picture , the one with the USB Cable plugged to Port , look at the NandFlash

on the right side is a small triangle , from there count to the Pins 7/8 , this Pins normal are used for

MaskromMode , can nearly done with every small Cupperwire , example Coaxcable , or real small

Screwdriver ,

install the right Drivers , start Flashtool , load Firmware , connect to PC , BUT , first without Power ,

short the Pins , hold it , now enter the Powersupply , if all was good a Sound comes up , then you can

see Connection in Tool and leave the Pins ,

Hint , for Restore it is always the best to use the Stockrom or known working Firmware ,

hope it helps / gefattern

[mAtvXk]

Images of my board are attached as I didn't find mine in that thread.

https://forum.freaktab.com/node/637675?p=638046#post638046

[AnasTechInfo]

https://forum.freaktab.com/node/637675?p=638046#post638046

Will Try...