If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
hi, i have some problem red light costantly red and black screen on tv after a firmware update... original firmware was that posted on photo. My mxq pcb is S805_MXQ_V03 20150816
i tried all metods shorting pins 17-18 without succes... please help me
You may only view thumbnails in this gallery.
This gallery has 3 photos.
you need to join ALE and WE on the nand (on my nand (H27UCG8T) it's pin 17 & 18).
If your nand is not an H27UCG8T, don't attempt this!
You'll never get any help just posting a picture because the board is different.
Nobody wants to be responsible for destroying your hardware!!
If you are incapable of using an ohm meter then you should not be doing this.
I mean no disrespect, this is just very difficult to perform if you are new at soldering.
I think it's to late, after few try with wire now afterwards my pc recognize the box but when I try flash with the USB burn tool it's stuck on 4% and get error, so I will throw the box I think it's broken
I think it's to late, after few try with wire now afterwards my pc recognize the box but when I try flash with the USB burn tool it's stuck on 4% and get error, so I will throw the box I think it's broken
Skickat från min D6603 via Tapatalk
Are you sure you have the right image. This was happening to me, sticks at around 4%. I got another image and it works fine. Image file is called
You can try to upload it to Mega or Google drive booth it's free
Ok do not use the NC4 file, it is firmware for a LG TV lol, sorry it was quite a few weeks ago when I unbricked my MXQ, anyway, here is the file I used to Unbrick my box, please let me know if it worked for you. I have included the USB burning tool. The password for the archive is http://freaktab.com
Did you try Erase All in settings, infact it should be force erase all, let me know
You can also try to flash the *.img firmware file without USB Burning tool: 1) Rename your *.img firmware file to aml_upgrade_package.img 2) Download the *.ini file: aml_sdc_burn.ini 3) Write this two files to your SD card 4) Put the SD card to your device, press the recovery button and put the power cable.
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment