Bricked PiPo S1 Pro Nand 29F64G08A

[MaX232]

Sorry for my very bad english
I flash a ROM from S1 to S1 Pro i didn't see it, open the tablet and try to boot in MaskRom but the nand isn't SanDisk is 29F64G08A... and don't works reset bridge the pins 8 and 9
What I can try?
Thanks

[rrileypm]

Try 7 and 8.

Otherwise, at this point...try other combinations. It wouldn't hurt.

Sent from my SAMSUNG-SGH-I537 using Tapatalk

[MaX232]

Thanks rrileypm for your response
I try to short 7 and 8 in the left and right up and down but doesn't work

1 - Open Rockchip Batch Tool v1.7 and load firmware i also try Finless ROM Flash Tool 1.37
2 - Bridge points
3 - Conect USB

is it correct?
Thanks

[rrileypm]

Have the USB connected and the flash tool running. When you get the correct pins, the tool will say "mask mode".

Sent from my SAMSUNG-SGH-I537 using Tapatalk

[MaX232]

YEEEEESSSSSSSS!!!!! the tablet back to the life, THANKS rrileypm for your help.
The points i bridge is near to Nand chip, if you see previous image, the pads located in the left side of the Nand chip, sorry i don't remeber the pins probably 7 & 8 or 8 & 9 start counting down pin to up pin
THANKS