[ROM] Unofficial OpenELEC for MK808B+ and MXQ

[kostaman]

Warth7
Hi Again
I have just gone through your post history and just realised YOU HAVE A CORRUPT ANDROID Operating system.
Do not try Flashing OpenELEC as you are wasting your time.
You must First find A WORKING ANDROID Operating System for your box before trying anything OpenELEC.
If i find anything i will let you know. In the meantime see link below for HD18Q Android roms.
Dont worry about remote or wifi not working in the roms as once you get the box to successfully boot into Android you can then Flash OpenELEC.
More than likely HD18Q will work as i looked at the remote.


http://mbox.co.za/forum/viewforum.ph...0d02bfa3c9312b

__________________________________________________ ______________________________
All Black MXQ: Running MXQ.arm-6.95.1.1 On Nand. Board Number: AM_MXQ_A 20150825

[kostaman]

how can you tell what openelec you have from the board. I'm still learning this. I know I have mxq v3_2 all black box.

I will make it a bit clearer.
On the footer of my posts or comments you will see my box is all black. Next is what version of OpenELEC I AM RUNNING.(Nand means not off an external SD Card) and last is the Board inside my Box.
I ask everyone with the ALL BLACK Boxes supply this information as there are so many Variations of the ALL BLACK boxes.
As an example my remote control is the same as THE RED STRIPE MXQ's

__________________________________________________ ______________________________
All Black MXQ: Running MXQ.arm-6.95.1.1 On Nand. Board Number: AM_MXQ_A 20150825

[Warth7]

[scooter2014]

That will be on the main Thread post. If the device you have does not work then Post a clear photo of the pcb showing chipsets. If your getting errors you most lickly have loaded wrong softwars before trying software. Yes you will need to un Brick the device. Links to how to will also be posted. 😁

[Warth7]

Please edit your quote regarding MXQ Builds are for the red stripe MXQ Boxes only. This is incorrect as it depends on your Board and remote.
I use the MXQ Arm Builds All black MXQ and it works perfect. If everyone would supply their Board And Version of OpenELEC at the foot of their post/comment we would have a much easier time
helping you.

__________________________________________________ ______________________________
All Black MXQ: Running MXQ.arm-6.95.1.1 On Nand. Board Number: AM_MXQ_A 20150825

how can you tell what openelec you have from the board. I'm still learning this. I know I have mxq v3_2 all black box.