OpenELEC 5.95.5 - 15.2 RC2 for S802 / s812 01.10.2015

[JustMe]

Since no one has compiled a newer version, here is current rls of OpenELEC 15.2 rc2 forked from Surkovalex Github you may need to replace the remote cfg file in order to work dependent on the box you use. quick search on forum will point you towards the right direction on how to do it.

enjoy

M8 or Most Amlogic K200 OE 6.0 - 15.2 rc3 - 16.10.2015

M8 OE 6.0 15.2rc3 update.zip

M8 OE 6.0 15.2rc3 TAR




----------------------------------------------------------------------------

01.10.2015 15.2rc2

M8 or Most Amlogic k200

Tar File : http://bit.do/EM8_OE_15-2rc2_tar
Zip FIle :http://bit.do/EM8_OE_15-2rc2




M8s or Most Amlogic n200

Tar File : http://bit.do/OE_5-95-5_n200_m8s_tar
Zip File : http://bit.do/OE_5-95-5_n200_m8s_zip


Warning
I'm not responsible or liable if you brick your device using any of these files.

This is not associated with openelec.tv so please do not ask on their forums for help as you will be redirect else where

[ramon125]

works great so far on my trmk1 box! Thnx justme!

[JustMe]

updated op

- added n200

[Crowland]

Please can you tell me which version is for the trmk1.

[JustMe]

first zip file

[markl]

NOOB here, Works great, I have loaded on my m8s and tried to update the remote but it still wont work any ideas? Thanks JustMe

[elgrego]

Just wondering, if I install this on my M8N how do you turn the box off. Usually you quit kodi then press the remote to put it to standby. So how does it work if you don't need to quit kodi?

[huggie]

Ive noticed under network that the wifi button isnt there to enable it. so does this only work via a wired connection

[Ricey155]

Not used it for a while but isn't it under OPENELEC tab ? its there

going to install openelec on my box again android is so slow and glitchy !

Ive noticed under network that the wifi button isnt there to enable it. so does this only work via a wired connection

[huggie]

In Openelec Thats where it should be under the network tab but theres on a wired button to click to enable using M8 or Most Amlogic k200

[Ricey155]

standard remote works fine for me, air mouse plugged into USB not so (I'll scan for a fix if there's one, happy googling)

rebooting the usb mouse came to life #GreatStuff

[DonnieH]

Thanks very much for the files. However, when I enter recovery on my square m8, the progress bar reaches about 2 thirds and stops. About 10 seconds later the little cage inside the robot stops spinning and then everything just stops there. Tried different SD cards but same results. Any ideas? Thanks

[JustMe]

...

[JustMe]

@ Donnieh try it from thumb drive what unit m8 or m8s

[DonnieH]

ok will do thanks. Its an M8.