I unfortunately bought a USB A Male to Male only to find that when I try to flash my boxes it doesn't work, I was hoping someone with the knowledge or experience could help me. Here's what I've tried.
I've connected the USB cable only to find that it provides power to my box and when I try to use the toothpick method (even though I don't use a toothpick) it gets stuck on the boot logo however I do hear it connect to my PC and show up in the USB Burning tool, but when I try to flash it it powers off at UBOOT installation, which I find odd..
Next I tried inserting both the power cable and the usb cable at the same time and using the toothpick method and the same error occured and the box shutoff.
I've tried getting into recovery mode by using a false .zip and updating from the software included but I get stuck at the boot logo and it wont go past it, only to have it error again and shut down if I try to flash it.
I've tried going into recovery by connecting just the power cable which WORKS however when I connect the USB cable it wont show up on my computer.
I've found if I just connect the USB it will power up like it had a power connect connected to it, could it be that is the problem?
This has happened on both My Mini M8S II and T95X both of which are S905X boxes. I'm pretty much stumped at this point.
Anyone have any ideas?
Thanks in advance!
Comment