CX-919 ROM flashing problems

[FadeFx]

AW: CX-919 ROM flashing problems

In order to follow the instructions here, I am supposed to keep the "Connect to PC" checked. Then remove all cables except the HDMI. After I get the ding on connecting the OTG to PC, the finless flash tool shows device found, but when I do "reflash" as per the instruction, it tells me the device is not msc device. When I connect it again to the TV and check its settings, the "Connect to PC" is unchecked.
Any ideas about how I should proceed?

You dont need to reboot to flash mode at all, you need to connect the device to your pc while holding the button on the device. This will boot it to flash mode directly and you can just flash over.

_________________________
tapatalked from GalaxyS3

[dovi17]

Thank you for your reply.

It seems that I used the wrong flash tool (not he one that cme with the ROM).

It works fin now!

[FadeFx]

AW: CX-919 ROM flashing problems

Thank you for your reply.

It seems that I used the wrong flash tool (not he one that cme with the ROM).

It works fin now!

You are welcome, i didnt even think of that possibility ...

_________________________
tapatalked from GalaxyS3

[Zoprano]

Good afternoon.


I have a CX-919, and I can not in any way make stay in flash mode, and is detected by the PC.


Someone help me?


Already installed W7 on a new PC, and even then I did.


When I turn, appears unknown device, and will not let me update the drivers.


I've tried everything I read here already testeii the program to install the drivers, and nothing works.

[Zoprano]

CX-919 ROM flashing problems




Zoprano Tapatalk