If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I wanted to take my 10 G2 back to the stock firmware after using Finless 1.4.
I followed the steps, was able to load the firmware. The device rebooted, did its thing, and said rebooting in 3..2..1 and then rebooted. Not it just keeps booting to the Arnova logo.
If you forcibly power it off (hold power down), it shuts down but then automatically comes back on with the logo.
If you try to go into recovery mode, my computer sees an unreconized device, but then instantly the logo comes up, and the computer recognizes it again.
Any thoughts on how to get this device back to the stock firmware?
You have to use RKBatch tool to flash the Arnova update.img. You cannot just put it on SD card.
Also if you are using the RKbatch tool, you click the restore button not the update button.
Bob
"Pzebacz im, bo nie wiedzą, co czynią"
"Прости им, они не ведают, что творят"
"Perdona loro perché non sanno quello che fanno"
"Vergib ihnen, denn sie wissen nicht, was sie tun"
"Vergeef hen want ze weten niet wat ze doen"
"Pardonne-leur car ils ne savent pas ce qu'ils font"
"Perdónalos porque no saben que lo que hacen"
"Oprosti im, jer ne znaju što čine"
"Forgive them as they know not what they do"
Here is a link to the RKbatch tool if you do not have it. FYI you do not have to reinstall drivers! Just run the tool and point the file name to the update.img file.
"Pzebacz im, bo nie wiedzą, co czynią"
"Прости им, они не ведают, что творят"
"Perdona loro perché non sanno quello che fanno"
"Vergib ihnen, denn sie wissen nicht, was sie tun"
"Vergeef hen want ze weten niet wat ze doen"
"Pardonne-leur car ils ne savent pas ce qu'ils font"
"Perdónalos porque no saben que lo que hacen"
"Oprosti im, jer ne znaju što čine"
"Forgive them as they know not what they do"
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment