Stuck On Arnova Logo

[BRRABill]

I wanted to take my 10 G2 back to the stock firmware after using Finless 1.4.

I followed the steps, was able to load the firmware. The device rebooted, did its thing, and said rebooting in 3..2..1 and then rebooted. Not it just keeps booting to the Arnova logo.

If you forcibly power it off (hold power down), it shuts down but then automatically comes back on with the logo.

If you try to go into recovery mode, my computer sees an unreconized device, but then instantly the logo comes up, and the computer recognizes it again.

Any thoughts on how to get this device back to the stock firmware?

[Finless]

You have to use RKBatch tool to flash the Arnova update.img. You cannot just put it on SD card.

Also if you are using the RKbatch tool, you click the restore button not the update button.

Bob

[Finless]

Here is a link to the RKbatch tool if you do not have it. FYI you do not have to reinstall drivers! Just run the tool and point the file name to the update.img file.

http://video.freaktab.com/?subpath=finless/tools&filename=rkbatchtool_14.zip

Bob

[BRRABill]

Hitting RESTORE was the key. I kept hitting update.

Your ROM was awesome. We just found the device (and Android in general) would not do what we needed, so we are returning it.

Thanks for putting so much time and effort into this project.