HELP : Bricked my UG007b

[opengl1971]

I bricked my TV UG007b stick by a wrong flash , normally i was always able to bring it back
By holding reset button and plugging usb cable at the same time , but this time it didn't work

So i refered to an old post here regarding one user bricked his UG007b stick and NEOMODE
Informed him to short pins 5-8 , but i am not sure what is ment by this

Does this means linking pins 5 and 8 or linking pins from 5 to 8 (i.e 5 ,6 and 6,7 and 7,8)
Or may be something else , can any one please help ?

[opengl1971]

I managed to bring it back.

(The following pin count are counted from the top left corner of the nand chip)

The solution was to connect (short) pins 5 and 6 with a needle , use another needle to connect pins 7 and 8 , while connecting the pins simultaneously plug in the usb cable , then it will boot
Into flash mode.

It is the same solution suggested before but i thought to write it in more details for newbies.

[hotte96]

question

hello opengl
I am a novice in the field.
I also have the problem that I can not flash my ug007b.
can you tell me exactly must show (which side) which I bridge pins (see picture) I have 2 marks, are you the right?


I've understood everything
1 leave pin 5 +6 over bridge short and get rid of
2 pin 5 +6 and 7 +8 pin bridge and keep
3 connect usb cable
is that correct?




what happens then?
tool with which I can then continue to work. I have to keep going with stockrom einerr or can I use a customrom.
thanks for help me

[hotte96]

My dongel is unbrickt

i have unbrick my g007b

http://www.android-hilfe.de/attachments/rockchip-rk3188-tv-sticks/283873d1392019212-unbrick-fix-nand-ug007b-rk3188-maskrom-rk3188.png

thx

HoTTe96

[Petronio]

Your post was usefull

I managed to bring it back.

(The following pin count are counted from the top left corner of the nand chip)

The solution was to connect (short) pins 5 and 6 with a needle , use another needle to connect pins 7 and 8 , while connecting the pins simultaneously plug in the usb cable , then it will boot
Into flash mode.

It is the same solution suggested before but i thought to write it in more details for newbies.

Thank-you so much for this information. I have been spend a long time to unbrick my MK809iii and you helped me!
Also, I got the correct firmware in http://www.freaktab.com/showthread.p...rer-s-firmware wich is the original one.
Thank you