MK 802 IIIs hang

[nimir]

is it possible to flash backup from recovery?
I don't have but if somebody will provide it for me...

[snakekiller]

is it possible to flash backup from recovery?
I don't have but if somebody will provide it for me...

try this

This is the most tricky part and you will need a Micro USB cable (connected to computer but NOT YET connected to MK802 IIIS) and a metal stick (or pin or needle) which is thin enough to pass through the air vent on MK802 IIIS (the reset button inside the air vent located on the side next to MicroSD card slot)




Try to press and release the reset button which produce a "Click" sound. This step is just to make sure you are able to reach the right button.

[nimir]

Windows not see my device, for this reason I go to bootloader from terminal just type su -i
reboot bootloader
and in this case my computer saw device, i flashed your rom and... now I stuck

[snakekiller]

Windows not see my device, for this reason I go to bootloader from terminal just type su -i
reboot bootloader
and in this case my computer saw device, i flashed your rom and... now I stuck

it sound like you do not installing the rk drivers on your pc .

[nimir]

I installed it already, wehen the device is in bootloader mode it appear in Windows.
I install driver from your zip file and later install your rom.
Without it how can I install rom?
Please do in recovery backup of clear rour rom and zip directory with backup and upload it somewere,
I'll try this way

Is it possible when device is in recovery CM flash rom?
Windows see RK3066 but I can't find driver for it

[nimir]

@snakekiller can you help me?

[snakekiller]

Re: MK 802 IIIs hang

Yes just short pin the 2 dots .
Like i said in the previous posts

Verstuurd van mijn GT-S5660 met Tapatalk

[nimir]

I have to connect together this point on chip and this legs on right side of chip????
I'll try again maybe with some metal sticker not screwdriver

[snakekiller]

Re: MK 802 IIIs hang

Just the 2 dots left on the chip
Hold it and connect to pc.
When you hear the connection with the pc you may loose the dots

Verstuurd van mijn GT-S5660 met Tapatalk

[nimir]

nothing, but my device board look a little bit different then this on picture

[snakekiller]

Re: MK 802 IIIs hang

Not worry if it is a little different.
Do you have the 2 solder dots?

Verstuurd van mijn GT-S5660 met Tapatalk

[nimir]

delete/....

[nimir]

no I don't have this solder dots, only 2 small holes on oposite side then this small button

[nimir]

@snakekiller I put device to maskrom mode i clean nand and flash bootloader but after that mk still hang on starting picture
what happened

[snakekiller]

Re: MK 802 IIIs hang

If you are in maskrom mode you must erase idb first.
Then tick loader.
And then click run

Verstuurd van mijn GT-S5660 met Tapatalk