Imito MX1 on finless ROM1.5
kernel 1080 with boot 1080 selected
Parameter 2gb app space chosen
Hi Guys!
After flashing finless 1.5 successfully without a hitch I wanted to increase the size of the icons and text on the 1080p screen. So I followed directions in the readme doc for changing the LCD density, by removing the # from the 240 line and adding # to the 160 line in the /system/build.prop file. As shown below...
#ro.sf.lcd_density=160
ro.sf.lcd_density=240
Saved then rebooted. After that, the only thing I see is the boot screen load.... then a Blank Screen!!! arrrgh . I tried powering off and on the device a couple times and every time a get I get the same result. Windows no longer detects the device and the internal SD card will not mount to PC. So I'm unable to see the Android OS and Windows no longer detects the usb device making reflashing impossible. Did I just brick my Imito device??
If so, should I try unbricking my MX1 by shorting out the pads as done with the UG802 unbricking process??
Or is there another way around where I can edit/replace the build.prop file to its original state?
Any advice,
much appreciated,
thanks,
Knowdough
Comment