FTMC Jarvis 16.2.31

[Don_Pachuco]

is there a newer build than what came on the custom SC ROM for Beelink Ultimate? I seem to have lots of issues with my Pulse CCM build since using FTMC as opposed to true Kodi.

[superceleron]

True, but the ppl always like the latest as you know lol
But i as getting to the limite that i could do on 16 so was time to move on.
And yes the 16 still have lots of life ahead

[bluesmanuk]

well you now can try amlcodec in ftmc krypton, you can use it along side ftmc build 16.2.30 ( DONT ASK FOR IT.... INTERNAL FT TEAM TEST BUILD)

I'm sure that you will do an excellent job as always and as you say, this Jarvis version has a lot of life in it yet and could not ask for more funtionality than this offers.

Or at least for me as although I use Krypton on other platforms, I've yet to utilise anything new that it offers,

[superceleron]

Ran 20 Aml through it's paces and all still works perfectly for me.

well you now can try amlcodec in ftmc krypton, you can use it along side ftmc build 16.2.30 ( DONT ASK FOR IT.... INTERNAL FT TEAM TEST BUILD)

[bluesmanuk]

Ran 20 Aml through it's paces and all still works perfectly for me.

[mikele]

thanks. you rock.
curiously I can not update from 29 build..
I have to remove build 29 to install this build (Marshmallow 6.1 TX8 S912 Device)

Edit: My bad : I tried to install x86 version ... I'm lost ! Arm update fine

[m1pnk]

those on 4.4 .... if the factory/supplier dont have firmware updates for 5.1 +.... time to get a new gadget.... just the same as that draw full of old phones....

[scooter2014]

Hes leave it perfect for 4.4 devices so still best for you.

[Gellimo123]

thnx for al the work, still it sad that there wil be no more builds for android lower than android 5, my minix wil never go higher than 4.4

[superceleron]

Updated 1º post with build 30...
THIS IS MY LAST BUILD OF FTMC JARVIS, AND SHOULD LAST FOR SOME TIME!
in 1 or 2 months i will open the source tree!
Krypton build already testing, one thing.. NO SUPPORT FOR LOWER THAN ANDROID 5.

[Gellimo123]

since a few days my ftmc (lates version) wont load anything when i activate my vpn, before it works perfect

[android_dev]

Can I get the source code for FTMC v 29?

[superceleron]

He SuperCeleron have you seen latest SPMC update

Build updated:

• HQ scalers are back
• Revert amcodec to working Jarvis one
• Added Samba 4.5, thus SMB2/SMB3. SMB3 is default, but there is a setting to revert to SMB1.

Yes i have seen, must are krypton only... i m8 use one or another!

[EagleEyeXZ]

He SuperCeleron have you seen latest SPMC update

Build updated:

• HQ scalers are back
• Revert amcodec to working Jarvis one
• Added Samba 4.5, thus SMB2/SMB3. SMB3 is default, but there is a setting to revert to SMB1.

[gjac1]

There is no setting that you can change in the FTMC interface that can change this.

But I'm sure that Superceleron will see this and can perhaps factor this into the next version.

Thank you for your very fast reply