NAND Chip Mask ROM Mode Short Location

[djf1ame]

Hi need help shorting this.

X96Q 4+64 H313
Using KLM8G1WEMB-B031 eMMC.

Tried my best on trying to find it. Even scratched off some off the board to try short.

http://www.datasheetcafe.com/klm8g1wemb-b031-datasheet-emmc-nand-flash-memory/

Good point, it does have a tuner so you are limited to which ROM you can run on it. I believe the original ROM was 4.2.2 on that box. As you need all the firmware modules for channel selection and scanning.

And it's only a dual core 1.2 thru 1.5g


Cheers

[soldiaz]

Yes very old but has tuner built in...

don't even bother with that box... you can buy one cheap online for $20 or less with s905x or better processor 1g/8g

the processor on that board is worthless AML8726

[Yousef515]

Need better pics closeup. And chances are that chipset is really old... it might not be worth doing anything with it. It depends... the board is dated 2014 .... s8xx s9xx series.... super slow.


get me somemore info.... cheers

https://m.pt.aliexpress.com/item/32475207234.html?trace=wwwdetail2mobilesitedetail

Need better pics closeup. And chances are that chipset is really old... it might not be worth doing anything with it. It depends... the board is dated 2014 .... s8xx s9xx series.... super slow.


get me somemore info.... cheers

[Yousef515]

Please

Method #1 (bricked)

Start usb tool with rom loaded, plug in USB

touch between pin 5 and 6 on this side as shown in arrow.


Method #2 (if hard bricked)

Start usb tool with rom loaded, short 5 and 6 with needle and keep in on pins, while plugging in the USB
it will start to flash.


Cheers

[N3bi2]

Hi Anybody know witch pins short about nand chip mask in my case?

samsung KLMAG2GEAC - B002

[Pandaii]

Anybody know about nand chip mask rom of my box?

in circle pic is small but that should be it

[Pandaii]

Hi, I need help finding the NAND of my Csa96 rk3399

[Pandaii]

Hi, I need help finding the NAND of my Csa96 rk3399

[channdy]

Hi, I bricked my TX3 mini, NAND chip SANDISK SDINADF4-16G, could someone show me which pins I have to short, thanks

Ben

Hi, I have the same problem. Did you get it resolved?

[oroboi]

Can someone help me with this cheap MXQ PRO 4k 5G ive got, it got brick when i install MAGISK on it, now im having a hard time unbricking it since i dont know where is its pin for MASKROM Mod, anyone can help would be greetful. Than you in advance.