NAND Chip Mask ROM Mode Short Location

[Guest]

...T95Q with the chip 905x2...

[4PDA.ru]

[Adore]

hello again
thanks for the fast answer, but unfortunately it's not working!
Tried with USB cable and the power adapter connected but nothing!

Remains with the blue light on, and it's not recognized by computer

more suggestions please?

[Adore]

[4PDA.ru]

Well ... after some time trying to find it, luckily I found it!
Thank you very much

[senabaj]

Well ... after some time trying to find it, luckily I found it!
Thank you very much

on the left two copper circles are the first pins

[Holy_Ghost]

Can some one help me with finding the nand pins to short and connect my android box its H96 max rk 3318 model please help guys.

[Guest]

Holy_Ghost , check this post about H96 MAX X2, amlogic device related to yours, you have to shorten copper dots.

[kipir]

[mr smith]

Can someone help me to find the nand pins to short
model aun box 1 rk 3229

[phsaugo]

could help me identify the pinout of this board. Thanks

https://ibb.co/Z8W6GRD

[Guest]

could help me identify the pinout of this board ... Chinese TX9

Swipe with metal object through the blue ones first (if it doesn't work try all yellow ones),
but to get device working you must have original firmware from manufacturer.

[phsaugo]

Thank you. But the problem is that I don't have the .img firmware and I also can't access twrp to restore the backup. At least needed to record the boot to be able to access via twrp. I looked in the posts you made reference to, but none of them have an .img image for usb-burn-tool

[Guest]

...I looked in the posts you made reference to, but none of them have an .img image for usb-burn-tool

Unfortunately, that is the reality.

[pindonga123]

Can anybody help me?. I have the nand of the first photo, h26m4113 but I do not see well which are the pins that I have to short if it is the 6-7, 7-8 or both. What would be the process? do I short circuit those pins and then connect the usb cable? Or should I make the short circuit, press the reset button and then connect the usb. I already tried doing the above and the PC does not detect the device, or I am burning something or something I am doing wrong. Only the red light comes on

[phsaugo]

I also tried to do the pinout scheme and I didn’t succeed, it’s only in the Red light. follow the steps below that I performed.
- I connected the cable to the board and the PC
- I shorted the pins and turned the card on
- the usb burn tools process starts but fails.

[w3r3w0lf]

Mecool KM3, KM9, KM9 Pro

My KM9 voice worked almost like this post by remark my thanks for it.

I have to pin 5 and 6 but at the same time press the reset button.
Then i plugged the usb to usb cable and the box turn on and i flashed new rom.