Big thx to Kerber
Announcement
Collapse
No announcement yet.
Announcement
Collapse
No announcement yet.
OpenELEC for s82, M8, MXIII, Tronsmart S89
Collapse
X
-
Originally posted by roolmapool View Post
Big thx to Kerber
-
Originally posted by MikeD View Post
the same and off by 5 hours. Rebooted several times, no change.
Regards .
Aceraaa
Leave a comment:
-
Originally posted by dankec View PostIt seems that in openelec 5.0.3 pr2 23.976 stuttering is finally fixed!
http://www.freaktab.com/showthread.p...l=1#post282905
Just wait than Kerber release 5.03 to ours S82/S89 devices
Leave a comment:
-
It seems that in openelec 5.0.3 pr2 23.976 stuttering is finally fixed!
Leave a comment:
-
-
New this site!
Hi everyone,
Like this site a lot. I need a little help here, I have OpenELEC Ver :4.97.2 and my time is stuck on
Jan 1, 1970. I can't seem to find were you can set the date and time.
Could someone direct me to the location to set date and time.
Other than that all is working extremely well.
Thanks in advance
AceraaaLast edited by Aceraaa; 02-14-2015, 22:23.
Leave a comment:
-
Originally posted by AndreaSpooky View Postkinda noobie on the linux side, so
how am i supposed to flash another version of openelec over the old one (or another version of linux)?
Leave a comment:
-
kinda noobie on the linux side, so
how am i supposed to flash another version of openelec over the old one (or another version of linux)?
Leave a comment:
-
Originally posted by d3ft View PostDone all of that. I end up with a list of muxes that won't scan.
So, You will get it, it is just a setting that you are missing.
Leave a comment:
-
Originally posted by clarkss12 View PostWhat steps did you take?
Under TV adapters, you will see your HDHomeRun and two tuners, you click them and then enable each tuner and select ATSC . Also create a network, and select a predefined MUX.
https://www.youtube.com/watch?v=VtnwqZNT4p8
Leave a comment:
-
Originally posted by d3ft View PostI updated the firmware on my HDHR and have gotten TVheadend to see it through the web interface (connected via ethernet to the S89). Unfortunately, all the setup guides appear to be for an older version of Tvheadend as mine looks completely different. I've tried to get it to scan channels but it just sits there saying "PENDING".
Under TV adapters, you will see your HDHomeRun and two tuners, you click them and then enable each tuner and select ATSC . Also create a network, and select a predefined MUX.
Leave a comment:
-
OpenELEC for s82, M8, MXIII, Tronsmart S89
Originally posted by d3ft View PostI updated the firmware on my HDHR and have gotten TVheadend to see it through the web interface (connected via ethernet to the S89). Unfortunately, all the setup guides appear to be for an older version of Tvheadend as mine looks completely different. I've tried to get it to scan channels but it just sits there saying "PENDING".
Leave a comment:
-
Originally posted by clarkss12 View PostThat could be the reason, not really sure. But if you verify that it will see your tuner by WiFi, then you can go from there.
Leave a comment:
What's Going On
Collapse
There are currently 3141 users online. 5 members and 3136 guests.
Most users ever online was 16,134 at 08:28 on 08-11-2023.
Leave a comment: