NAND Chip Mask ROM Mode Short Location

[virusviki]

I have t9 rk3328 box 4+64gb. Tried upgrading the firmware and it failed which resulted in no power and no boot.
I am looking forward to short the pins and then try uploading firmware.

[Hotrod1]

I have t9 rk3328 box 4+64gb. Tried upgrading the firmware and it failed which resulted in no power and no boot.
I am looking forward to short the pins and then try uploading firmware.

Check this thread on XDA I think it has your solution.

https://forum.xda-developers.com/t/t...-fail.4137369/

[tteodor]

Hi again
I have problem with A95X F3 air .Only red light.Can samobody help pls?

[joseac]

Hello, this tv box is badly flashed and now it is not detected by the Amlogic burning tool, where will the test points be?, thanks.

[raul.velis]

Friends, I am new to this post and I wanted to explain that I have a Mecool KM9 pro Deluxe tv box, and I have blocked the equipment after using a fake rom using the Anlogic USB burning tool method. Now the device turns on the blue LED but I have no video output and I have tried some methods to try to revive it, such as: burn card maker through the .img file. I would appreciate if someone could tell me where I locate the pins on the board using the short pin method and I can have the tv box with me again. Funny

[ath156]

raul.velis

Try the 2 pins inside the red square I have placed to your photo. These must be the correct points to short, but as always whatever you do you are doing it at your own risk. Good Luck.

[raul.velis]

ath156

Thank you. I will try and tell you later

[phankhanh86]

Hello, this tv box is badly flashed and now it is not detected by the Amlogic burning tool, where will the test points be?, thanks.

short two hold

[joseac]

short two hold

Thanks, I'll try later.

[joseac]

short two hold

Thanks! It was those points, it works again.

[raul.velis]

ath156

Thanks! It was those points

[raul.velis]

ath156

Hi friend. I have a Mecool KM9 pro deluxe tv box that is
brick and I have tried to flash it with the USB burning Tool. I have tried with some android tv 9 stock roms, but it always gives me the same error 3%
Uboot/Get result/DiskInitial error
I want to try with an Android tv 10 stock rom, because it is the version I had before Brick was put in, the thing is that I have not been able to get any that is in .img to be able to flash it with the USB burning tool. Someone could port a rom prepared in .img and let it be ATV 10 for this tv box. I would really appreciate it if you could help me

[dodbda]

Hi guys, help me with the board below, pls

Amlogic s905x - Q96 MINI (A95X R2)


Thanks!!!

[rex2323]

Hi guys, help me with the board below, pls
X96q need short pin for this model for installons atv9
And please send me link of original firmware x96q 4gb 32gb thanks

[rex2323]

Как прошиться если китайцы кнопку reset не завезли (кнопка тупо не припаяна, выяснил при разборке)